Traxxas 67054-1 Manual do Utilizador descarregar pdf (Página 11)

STAMPEDE 4X4

•

TRAXXAS TQ 2.4GHz RADIO SYSTEM

RADIO SYSTEM RULES

• Always turn your transmitter on first and off last. This procedure

will help to prevent your model from receiving stray signals from

another transmitter, or other source, and running out of control.

Your model has electronic Failsafes to prevent this type of

malfunction, but the first, best defense against a runaway model

is to always turn the transmitter on first and off last.

• Always use new or freshly charged batteries for the radio system.

Weak batteries will limit the radio signal between the receiver and

the transmitter. Loss of the radio signal can cause you to lose

control of your model.

• In order for the transmitter and receiver to bind to one another,

the receiver in the model must be turned on within 20 seconds

of turning on the transmitter. The transmitter LED will flash fast

red, indicating a failure to link. If you miss it, simply turn off the

transmitter and start over.

• Always turn on the transmitter before plugging in the battery.

RADIO SYSTEM BASIC ADJUSTMENTS

Steering Trim

The steering trim knob located on the face of the

transmitter adjusts the neutral (center) point of the

steering channel. If your model pulls to the right or

left when the steering wheel is centered, turn the knob until the

model drives straight when the steering wheel is centered.

Channel Reversing

The TQ 2.4GHz transmitter has been programmed with the

correct servo direction settings for your model and should not

require adjustment. These instructions are for reference and

troubleshooting only.

Reversing a channel reverses the direction of the corresponding

servo. For example, if you turn the steering wheel to the right

and the model turns left, Channel 1 would need to be reversed to

correct the servo direction. Use the following procedures to reverse

the steering and throttle channels, if necessary. Servo reversing

should only be required if you accidentally reset the direction of

a channel. Do not reverse the steering or throttle channels unless

necessary.

Steering reversing procedure:

1. Press and hold the SET button on the transmitter for two

seconds. The status LED will ﬂash green.

2. Turn and hold the steering wheel to the full left or full right

position (it does not matter which position you choose).

3. While holding the steering wheel in position, press the SET

button to reverse the channel.

4. The channel is now reversed. Conﬁrm correct servo operation

before running your model.

Always turn your

transmitter on ﬁrst.

Turn on the model.

Plug in the battery.

RADIO SYSTEM CONTROLS

Forward

Neutral

Brake/Reverse

Remember, always turn the

transmitter on ﬁrst and off

last to avoid damage to your

model.

When rechargeable batteries

begin to lose their charge,

they will fade much faster

than alkaline dry cells. Stop

immediately at the ﬁrst sign

of weak batteries. Never turn

the transmitter off when the

battery pack is plugged

in. The model could run out

of control.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Comentários a estes Manuais

Sem comentários

Traxxas 67054-1 Manual do Utilizador Página 11

Comentários a estes Manuais

Manuais e produtos relacionados com Brinquedos Traxxas 67054-1